FTM Board Club
WIZnet
WizFi360-EVB
Development board for WizFi360

WizFi360-EVB is a development board for experiment, test and verification of WizFi360. WizFi360-EVB can also be used as an Arduino shield.

WizFi360 is a low cost and low-power consumption industrial-grade WiFi module. It is compatible with IEEE802.11 b/g/n standard and supports SoftAP, Station and SoftAP+Station modes. The serial port baud rate can be up to 2Mbps, which can meet the requirement of various applications.

Features
  • WiFi 2.4G, 802.11 b/g/n

  • Support Station / SoftAP / SoftAP+Station operation modes

  • Support “Data pass-through” and “AT command data transfer” mode

  • Support serial AT command configuration

  • Support TCP Server / TCP Client / UDP operating mode

  • Support configuration of operating channel 0 ~ 13

  • Support auto 20MHz / 40MHz bandwidth

  • Support WPA_PSK / WPA2_PSK encryption

  • Serial port baud rate up from 600bps to 2Mbps with 16 common values

  • Support up to 5 TCP / UDP links

  • Obtaining IP address automatically from the DHCP server (Station mode)

  • DHCP service for Wireless LAN clients (AP mode)

  • Support DNS for communication with servers by domain name

  • Support “Keep-Alive” to monitor TCP connection

  • Support “Ping” for monitoring network status

  • Built-in SNTP client for receiving the network time

  • Support built-in unique MAC address and user configurable

  • Support firmware upgrade by UART Download / OTA (via WLAN)

  • Industrial grade (operating temperature range: -40 C ~ 85 C)

  • CE, FCC certification

  • Built-in UART to USB chip

  • CP2104-GM

  • Micro USB B Type Connector

UART Selector

  • JP1, JP2, JP3

Built-in Sensors

  • Temprature/Humidity Sensor: DHT11

  • CDS Sensor: GL5537

Built-in Tact Switches

  • System Reset Switch: S1

  • WiFi Reset Switch: S2

Built-in LED Indicators

  • D13 LED

Built-in Level Shifters

  • The voltage of the RXD/TXD signal changes according to the main board platform voltage.

Built-in DIP Switchs

  • UART RXD/TXD Selector: SW1

  • UART RTS/CTS Selector: SW2

  • Sensor/RESET Pins Selector: SW3